Glue scoop Glue comb 50mm

It is desirable to purchase the correct size for an easy, fast and beautiful finish. Which size you need depends on the wall thickness. You can use the wall thickness of your project for this. The glue scoops have been specially developed for the quick and even application of glue mortar to the butt and ribbon joints of aerated concrete and limestone walls. The glue scoops are coated for a long life and are therefore reusable for your next job. This product should therefore not be missing in your toolbox!

Preparation

Pour the desired amount of aerated concrete adhesive into a mixer, tub, bucket, wheelbarrow. Add the appropriate amount of clean tap water and mix thoroughly until a homogeneous and lump-free mass is obtained. Mix preferably with a mechanical mixer for at least 4 minutes.

Apply

Apply the adhesive mortar to the block with the adhesive shovel and trowel. For optimum adhesion, a permanent layer thickness of 2-3mm should be applied. The Blocks must be tapped with a rubber mallet.

Post-treatment

In the event of bulging glue residues, the end surface is smoothed with the glue trowel. After processing, protect the surface for three days against driving rain and drying out by wind or heat. (cover with foil)